RouterOS handleiding

/ipv6/nd

nd

IPv6 Neighbor Discovery (ND) protocol is configured.


ipv6/nd

Type: Directory

IPv6 Neighbor Discovery (ND) protocol is configured.

<ArgTableRow arg="X" typ="disabled">disabled</ArgTableRow> <ArgTableRow arg="I" typ="invalid">invalid</ArgTableRow> <ArgTableRow arg="*" typ="default">default</ArgTableRow>

Interface on which to run neighbor discovery. -all - run ND on all running interfaces.

<ArgTableRow arg="ra-interval" typ="super { min: time [3 .. 1250] , [max] -time [4 .. 1800] }">Minimum and maximum interval allowed between unsolicited multicast router advertisements from the interface.</ArgTableRow> <ArgTableRow arg="ra-delay" typ="time">Minimum time between multicast router advertisements from the interface.</ArgTableRow>

The MTU option in router advertisements ensures that all nodes on a link use the same MTU value when the link MTU is not well known.

  • unspecified - do not send the MTU option.

<ArgTableRow arg="reachable-time" typ="alt { special: enum (unspecified) { unspecified:0 } , value: time [ .. 3600] }">Time that RouterOS assumes a neighbor is reachable after receiving a reachability confirmation. Used by Neighbor Unreachability Detection (see Section 7.3 of RFC 4861).</ArgTableRow> <ArgTableRow arg="retransmit-interval" typ="alt { special: enum (unspecified) { unspecified:0 } , value: time }">Time between retransmitted Neighbor Solicitation messages. Used by address resolution and Neighbor Unreachability Detection (see Sections 7.2 and 7.3 of RFC 4861).</ArgTableRow> <ArgTableRow arg="ra-lifetime" typ="alt { special: enum (none) { none:0 } , value: time [ .. 9000] }">Set the RA lifetime. A lifetime of 0 indicates that this router is not a default router. See Section 6.2.1 of RFC 4861.</ArgTableRow> <ArgTableRow arg="ra-preference" typ="enum (low | medium | high)">Specify the router preference communicated to IPv6 hosts in router advertisements. The ra-preference value helps hosts select a default router to reach a remote destination.</ArgTableRow> <ArgTableRow arg="hop-limit" typ="alt { special: enum (unspecified) { unspecified:0 } , value: num [ .. 255] }">Default value placed in the Hop Count field of the IPv6 header for outgoing unicast packets.</ArgTableRow> <ArgTableRow arg="advertise-mac-address" typ="bool">When set, include the outgoing interface's link-layer address in router advertisements.</ArgTableRow>

Redistribute DNS server information using RADVD.

  • no - do not advertise DNS servers.
  • yes - advertise DNS servers installed on the router.
  • self - advertise the interface link-local address as the DNS service provider.

<ArgTableRow arg="managed-address-configuration" typ="bool">Indicates whether hosts should use stateful autoconfiguration (DHCPv6) to obtain addresses. See RFC 3315.</ArgTableRow> <ArgTableRow arg="other-configuration" typ="bool">Indicates whether hosts should use stateful autoconfiguration to obtain additional information, excluding addresses. See RFC 3315.</ArgTableRow> <ArgTableRow arg="dns" typ="multi { address: address (flags=6) }">Specify one or more IPv6 addresses that hosts receive for DNS server configuration.</ArgTableRow> <ArgTableRow arg="pref64" typ="object { pref64: ip6Prefix }">Specify one or more IPv6 prefixes within /32, /40, /48, /56, /64, or /96 subnets that hosts receive as NAT64 prefixes.</ArgTableRow>

Bron

Zoek je hoe de configurator zelf werkt? Handleiding bij de configurator

Bijgewerkt op 2026-11-01.