RouterOS handleiding

Monitor



interface/bridge/monitor

Type: Command

<ArgTableRow arg="state" typ="enum (disabled | disabled | enabled | enabled)"></ArgTableRow> <ArgTableRow arg="current-mac-address" typ="macAddr"></ArgTableRow> <ArgTableRow arg="bridge-id" typ="composite { prio: num , mac: macAddr }"></ArgTableRow> <ArgTableRow arg="root-bridge" typ="bool"></ArgTableRow> <ArgTableRow arg="root-bridge-id" typ="composite { prio: num , mac: macAddr }"></ArgTableRow> <ArgTableRow arg="regional-root-bridge-id" typ="composite { prio: num , mac: macAddr }"></ArgTableRow> <ArgTableRow arg="root-path-cost" typ="num"></ArgTableRow> <ArgTableRow arg="root-port" typ="iface_enum { none:0 }"></ArgTableRow> <ArgTableRow arg="port-count" typ="num"></ArgTableRow> <ArgTableRow arg="designated-port-count" typ="num"></ArgTableRow> <ArgTableRow arg="mst-config-digest" typ="string"></ArgTableRow> <ArgTableRow arg="fast-forward" typ="bool"></ArgTableRow> <ArgTableRow arg="multicast-router" typ="bool"></ArgTableRow> <ArgTableRow arg="igmp-querier" typ="composite { interface: iface_enum { none:0 } , ip-address: ipAddr }"></ArgTableRow> <ArgTableRow arg="mld-querier" typ="composite { interface: iface_enum { none:0 } , ipv6-address: ip6Addr }"></ArgTableRow> <ArgTableRow arg="declared-vlan-ids" typ="multi { vlan-range: range }"></ArgTableRow> <ArgTableRow arg="registered-vlan-ids" typ="multi { vlan-range: range }"></ArgTableRow> <ArgTableRow arg="mlag-state" typ="string">Shows the MLAG connection state: connected when ICCP is established, connecting while the peers establish or re-establish the connection, or an error such as peer port not running when the configured peer port is unavailable.</ArgTableRow> <ArgTableRow arg="mlag-active-role" typ="enum (primary | secondary)">The peer with the lowest priority acts as the primary device. If the priorities are the same, the peer with the lowest bridge MAC address becomes the primary. The system-id of the primary device is used for sending the (R/M)STP BPDU bridge identifier and LACP system ID. The role is shown after a successful MLAG connection.</ArgTableRow>

Bron

Zoek je hoe de configurator zelf werkt? Handleiding bij de configurator

Bijgewerkt op 2026-10-01.